Embedded Files
Finished Installing?
Finished Installing?
Additional Resources
Additional Resources
Edge Lit Low Clearance Exit Sign Install Guide
Edge Lit Low Clearance Exit Sign Install Guide
HEX-A-L Low Clearance Edgelit Exit Sign Install Guide.pdfEdge Lit Recessed Exit Sign Install Guide
Edge Lit Recessed Exit Sign Install Guide
HEX-A-R Recessed Edgelit Exit Sign Install Guide.pdfStep by Step Guide
Step by Step Guide
Unbox and Identify Components
Ensure you have the emergency light/exit sign and its battery.
Plug in the Battery
Locate the port labeled "B-A-T" on the circuit board inside the device.
Plug the battery into this port.
Attach the Cover
Once the battery is connected and the light turns on, replace the cover.
Connect to Power
Connect the device to your normal voltage power supply.
Check the LED Indicator
Green LED: Device is powered correctly, battery is connected, and communication with the platform is active.
Red LED: Battery is not connected correctly.
No LED: Device is not receiving power.
Ensure Proper Operation
Verify the LED status during and after installation to ensure proper setup.
Page updated
Report abuse