Ironman Helmet

By Andy Yeh

It has been two weeks, since I started printing a wearable Ironman helmet. But no, I actually did two of them. Can you see the differences?

iron man helmet (wearable)

https://www.thingiverse.com/thing:3236642

5 pieces, printed at 106%. This is still slightly smaller than the one on the left.

All the pieces (except for the ear pieces glued) are connected by strong magnets so they snap together easily.

Both are wearable. See Andy and Kelli in action below.

They took very long time to print on my TEVE Little Monster using Repetier Host. The 5 pieces one for example, the helmet (red piece) along took 37 hours to print due to a huge block of support. Therefore, I would not recommend to print this model. The 11 pieces one is a better one to print (with my improved version).