Laurel Manor Lighting

Startup
All sliders are fully down, except the Master fader, which should be fully up.
Connect the 5-pin cable between the console (DMX 1) and the wall jack.
Plug the power adapter into a 120 vac wall outlet.
The console should start by itself in a few seconds. If it does not, press Mode to start.

Load Show File; this step can usually be skipped

Select Memory Page; this step can usually be skipped.

Press the Mems button. If the red button #1 at the bottom is not bright red, press the Mems and #1 buttons together.

Lighting the Stage, after Startup, the numbered sliders become active:

1. All stage lights on (Red, Green, Blue, White). This is as bright as it gets.
2. Center the stage lights on.
3. Stage right lights on.
4. Stage left lights on.

5-24 {varies, show defined}

Brightness can be adjusted by the individual (1-24) fader or the Master fader.

These scenes were programmed because it was thought they should handle most productions. Of course, additional scenes can be programmed into any of the unused slots.

Shutdown

   All faders down
If some stage lights are still on, press Clear 4 times.
Press the Mode button, then the Menu/Yes button.
Wait for it to turn itself off.
Disconnect the 5-pin cable between the console and the wall jack.
Unplug the power adapter from the wall outlet.