2.42 inch 128x64 No Name - 7-wire

Convert to I2C

  • R17: Remove 472 resitor

  • R15: Add 472 resitor (from R17)

    • Note: This R15 next to R17 could be mis-labelled as R18

  • R13: Add 000 resistor

  • R18: Add 000 resistor

    • Note: This is the R18 resistor next to the CS Pin.

Notes:

  • 472 resistor = 4.7k ohm resistor

  • 000 resistor = 0 ohms resistor. Can be replaced with wire or solder blob.

Connect to Gotek

  • CS: Not Connected

  • DC: Not Connected

  • RES: Connect to the Gotek RST Pin

  • SDA: Connect to Gotek DISP_CLK J7 Pin

  • SCL: Connect to Gotek DISP_DIO J7 Pin

  • VCC: Connect to Gotek 3.3V J7 Pin

  • GND: Connect to Gotek VSS J7 Pin

Gotek J7 Pins:

Gotek Power and Programming Pins: