2.23 inch 128x32 OLED by Zhongjy Tech
Convert to I2C
Convert to I2C
R8: Remove 472 resistor
R7: Add 472 resistor (from R8)
R4: Add 000 resistor
R6: Add 472 resistor
R3: Add 472 resistor
Notes:
472 resistor = 4.7k ohm resistor
000 resistor = 0 ohms resistor. Can be replaced with wire or solder blob.
Connect to Gotek
Connect to Gotek
CS (Not Connected to Gotek)
DC: (Not Connected to Gotek)
RES: (Not Connected to Gotek) (Pulled up to VCC via 472 resistor at R6)
SDA: Connect to Gotek DISP_CLK J7 Pin
SCL: Connect to Gotek DISP_DIO J7 Pin
VCC: Connect to Gotek 3.3V J7 Pin
GND: Connect to Gotek VSS J7 Pin
Gotek J7 Pins:
FlashFloppy Config
FlashFloppy Config
In FF.CFG for display-type, you will need to use the -ztech suffix
See for further information:
https://github.com/keirf/FlashFloppy/wiki/FF.CFG-Configuration-File#display