This section is on the procedures that are needed to change tools on a 3636 ShopSabre.
For this procedure you will only need 2 tools being
Spanner Wrench
27mm Wrench
This will be done in a step by step process
Ensure E-Stop is engaged (Important)
Place spanner wrench to where it's engaged with the spindle nut (see image 1)
Place 27mm Crescent wrench along flat part of the spindle (Show in video)
Push the both wrenches towards each other to loosen spindle nut
Take out the collet ( shown in image 3) by pressing it to one side of the spindle nut
Take out tool from collet and change it for the desired tool
E-Stop
Image 1
Image 3 (Collet)
Once the spindle nut and collet have been taken out of the chuck slide the previous bit out of the collet
Insert the new bit that will be used into the collet as indicated in the video
2a. Note do not place bit too back in the collet as it may cause issues
If the new bit is a different diameter then what is suited for the collet a new collet will need to be placed to accommodate the bit's size
Place the spindle nut along with there collet and new bit in the shuck
Carefully turn the spindle nut clockwise in a way as to not damage the threads on the chuck
Once spindle nut is tightened by hand use the spanner wrench and the 27mm wrench in a motion of pulling them apart to further tighten and secure the spindle nut to the chuck
Dis-engage the E-stop and the machine is ready for use
VIDEO SHOWCASING THE WHOLE PROCESS