Step 1: Change from the 'Design' environment to the 'Manufacture' environment.
Step 2: Select the 'Setup' drop-down menu > Select 'New Setup'.
This will start the process of setting up the stock material and will open up a new window...
Step 3: Select the 'Stock' tab in the same setup window.
Change the mode from Relative size box to fixed size box.
Enter the following dimensions:
Width (X): 200mm
Depth (Y): 150mm
Height (Z): 18mm
Press 'OK' once complete. This will complete the stock setup.
Step 4: Fixing Any Problems - if your model does not fit inside the stock then you may need to change some of the axis.
Please note that if your model fits inside the stock and the Z Axis (blue line) points upwards then you may skip steps 5 and 6.
Step 5: Inside the setup window select the setup tab (the first tab).
Select the 'Model Orientation' drop down menu.
Select the 'Select Z Axis/Plane & Y Axis' option.
You will notice that the Z Axis cursor icon is now select prompting you to select the Z Axis...
Step 6: To select the new axis:
Select the Z axis cursor.
Select the Z axis as shown.
Select the Y axis icon.
Select the Y axis as shown.
Select the 'Box Point' cursor icon and select the corner shown - The corner should be the bottom left corner on the top face.
Please note that when you complete this stage successfully the Z axis should be pointing up towards the sky...
Step 7: Select the 'Stock Point: Box Point' cursor and select the corner shown.
The corner should be the bottom left corner on the top face.