HPE TW-TC - 5710 48XGT 使用注意事項

最近有通路夥伴在安裝 HPE FlexNetwork 5710 遇到介面速度綁定無法切換... 經查詢後這是晶片的關係..

請各位如果有規劃到這兩款交換器請特別注意一下 port 29~36 只能使用10G 介面連線無法降速成1G/100M

原始資料出處..

https://techhub.hpe.com/eginfolib/networking/docs/switches/5710/5200-4990_l2-lan_cg/content/517701136.htm

祝各位網路暢行無阻

Configuration restrictions and guidelines for Ethernet interfaces on the HPE FlexFabric 5710 switch series

By default, only interfaces numbered 49 through 54 on this switch series are 40-GE interfaces. The interfaces numbered 49, 51, and 53 are in one group and can be only combined into a 100-GE interface numbered 53. The interfaces numbered 50, 52, and 54 are in the other group and can be only combined into a 100-GE interface numbered 54. To combine three 40-GE interfaces in one group into a 100-GE interface, execute the using hundredgige command on any 40-GE interface in the group. To restore a 100-GE interface back to 40-GE interfaces, executing the using fortygige command on the 100-GE interface.

If any 40-GE interface in a group is split into four 10-GE interfaces, interfaces in the group cannot be combined into a 100-GE interface.

If any 40-GE interface in a group is configured as an IRF physical interface, the using hundredgige command is not supported on any interface in the group.

If a 100-GE interface numbered 53 or 54 is configured as an IRF physical interface, the using fortygige command is not supported on the interface.

Interfaces numbered 29 through 36 on the HPE FlexFabric 5710 48SFP+ 6QSFP+ or 2QSFP28 Switch (JL585A) do not support 1000-Mbps SFP modules.

Interfaces numbered 29 through 36 on the following switches can be only set to 10000 Mbps or configured to negotiate the 10000 Mbps interface speed with its peer:

HPE FlexFabric 5710 48XGT 6QSFP+ or 2QSFP28 Switch (JL586A).

HPE FlexFabric 5710 48SFP+ 6QSFP+ or 2QSFP28 Switch.(JL587A)

原始資料出處..

祝各位網路暢行無阻