Foundation: Chain 2
Round 1: 10 single crochet (SC) into the 2nd chain from the hook
Round 2: 2 SC into each each SC (total of 20 stitches)
Round 3: SC into each stitch (total of 20 stitches)
Round 4: 2 SC into each stitch (total of 40 stitches)
Round 5 through 8: SC into each stitch (total of 40 stitches 4 times)
Round 9: Single Crochet 2 together (SC2TGR)
Round 10: SC in each stitch (total of 20 stitches)
Round 11: SC2TOG (total of 10 stitches)
STUFF YOUR PUMPKIN
Round 12: SC2TOG (total of 5 stitches) slip stitch and close
Tie off leaving a 30 cm tail to sew in later.
Foundation: Chain 2
Round 1: 8 single crochet (SC) into first chain from the hook. Slip stitch (SS) to make a circle
Round 2: Chain 3, skip a stitch, SS into next stitch. Repeat this method 4 times
Leave a long tail to sew in on the pumpkin.
Step 1. First, use a square piece of paper. Fold the paper in half to make it look like a triangle
Step 2. Fold the sides to make the origami look like a rectangle for both sides
Step 3. Then, fold along all four creases at once to form a square with the open end facing you
Step 4. Now, fold the edges to make the paper look like a kite
Step 5. Then, fold the top part down
Step 6. Pull the bottom corner (top layer only) up above the top corner. Fold along the creases you made in steps 4 and 5. Repeat on the other side
Step 7. Fold all the bottom points up
Step 8. Pull two of the sides down
Step 9. Fold one of the tip of the sides
Finally, your end result should look like this.