Embedded Files
These standards are by no means an exhaustive list and is meant as a base standard of work. Unique situations will arise, please direct any questions towards the Project Manager or Superintendent.
NOTE: Plumbers responsibility to call in inspection and pass before work is considered complete
REFERENCE INFORMATION
REFERENCE INFORMATION
See blueprint page 102 for general layout for centering
See blueprint page 106 for cabinet layout for centering
BATHROOM
BATHROOM
Image 1
Shower pan must be attached to each stud
Image 2
Bathtub flange must be fastened to each stud
Image 3
Big gap foam must be installed between tub and floor
Image 4
P traps must be connected prior to insulation.
This image is a place holder.
Image 5
If studs are removed for valve installation than plumber is responsible for replacing stud within 10" of wall.
Image 2
Toilet plumbing water line must be installed through the wall, not through the floor.
PLUMBING LINES
PLUMBING LINES
Washer plumbing lines must be installed on the left side in laundry room (different for F plan)
5" nail guard plates are to be installed on all lines within 5" of top or bottom plate
Plumber to install vent lines through roof on the backside of the house. Vent lines must be properly connected prior to insulation.
PLUMBING VENTS
PLUMBING VENTS
Image 2
This image is a place holder.
Image 2
This image is a place holder.
Image 2
Plumbing vents must always be routed to the back side of the house (green highlight example), never on the front (red highlight example).
Image 2
This image is a place holder.
All plumbing penetrations through exterior walls must be fully sealed with silicone.
CRAWLSPACE
CRAWLSPACE
Hot water/pressure tank must have no leaks
This image is a place holder.
2 spigots must be installed on each house, one on the back and one by the driveway
This image is a place holder.
Sewer lines must exit where S is marked on the exterior wall. Confirm with SI or PM prior to drilling or digging through wall.
This image is a place holder.
APPLIANCES
APPLIANCES
Water line is installed behind refrigerator and must be leak free.
This image is a place holder.
Hardware clean and free of construction/installation material and drain line is properly marked.
All plumbing lines and fixtures must be leak free, especially under sinks.
This image is a place holder.
Fridge water inlet is installed 120" from corner of outer back deck wall.
This image is a place holder.
All trusses must be intact and uncut
Page updated
Report abuse