Calculation Points

Find it here:

MOUS_ICO Menu: Noise > Buildings > Calculation points

MOUS_ICO Menu: Noise > Buildings > Dialog box

MOUS_ICO Select one building in the list

MOUS_ICO Dialog box: Calc. points

nco: Select a building (defined in Novapoint Noise)

MOUS_ICO Popup menu: Calculation points

In calculation points, there is some advice about where to locate the calculation points both horizontally and according to ground level.

In this dialog box, we set up/change which calculation points are to be attached to a certain building. The identity of the building is given in the title of the dialog box.

Calculation points

Calculation points - Lists all calculation points defined in the drawing. A star (*) in the column Att. shows that this calculation point is already attached to a building. Calculation points may only be attached to one building. By clicking another point in the list, this will be attached to the relevant building and show up in the Attached calculation points list.
Number states the total number of calculation points defined in Novapoint Noise.
In list - is the number of calculation points in the filtered list.
Selected - is always blank since any selected point is immediately copied to the Attached calculation points and the selection is canceled.

Attached calculation points

Attached calculation points - Lists all calculation points attached to this building. By clicking a point in the list, the attachment will be removed.
Number - states the total number of calculation points attached to the relevant building.

Selection

From screen < - All dialog boxes are closed, and we may select one or several calculation points by selecting from the map. We get back to the dialog box by pressing <Enter>. The calculation points selected in the map will now be added to the list of attached calculation points.
Show on screen < - All dialog boxes are closed, and all calculation points in the list of Attached calculation points will be highlighted in red on the screen. We get back to the dialog box by pressing <Enter>.

Filter

Identity: - Here we select which calculation points are to be shown in the list of Calculation points. The filtering by name follows AutoCAD wildcard definitions (see “Wildcard Characters” in the AutoCAD help file).

Misc.

OK - The dialog box is closed and an attachment between the building and the calculation points in the list of Attached calculation points is established.
Cancel - The dialog box is closed without any changes being done.

Next topic: Delete