Scans
Scans can be effective for determining new frequencies, as well as therapeutic by themselves. Running scans is feasible only with a programmable function generator such as THE Q since manually entering a single frequency every few seconds hundreds of times in a session is not practical.
A good starting point found for scanning are 300 - 800 and 2000 - 2600Hz. Each frequency in a scan is run for 3 to 10 seconds. Any "hits" are noted and after the session these frequencies are run for a full three minutes each.
Hits are any frequencies which cause a sensation, such as tingling, pulsing, tickling, itching, etc.
Note that many times (if not most of the time) frequencies which are beneficial may not cause any sensation. And, many times frequencies which are hits may cause no apparent benefit. In general, though, frequencies which produce consistent hits over multiple sessions are usually therapeutic, and should be included in sessions until they no longer do.
THE Q has the ability to sweep about a chosen frequency with a predefined number of steps. For example, setting 728Hz with a contracting 3Hz scan at 20 seconds will yield 731, 725, 730, 726, 729, 727, and 728, running 7 frequencies for 20 seconds each for a total of 140 seconds. This may be a valuable method to more completely address a pathogen, particularly one which mutates. THE Q can be programmed using a default contraction with +/- 9Hz on each frequency, usually at 20 seconds each. This makes for long sets, but may be the best method for dealing with stubborn conditions.
The Resonance Of The BX With Its M.O.R (Why it cant be harmonics.)
• The dimensions of the BX vary from 40 nm (the size of its head starts from 24 nm) to 10 μm
• If Rife was targeting chemical constituents, not the entire microorganism; the molecules are even smaller
• Now we convert, for example, the wavelengths of 10 nm to 2 μm to frequencies, we have from 29.9792458 petahertz to 149.896229 terahertz
• There is no way to use even the highest M.O.R. (Mortal Oscillatory Rate) of earlier Rife machines, 1,604,000 Hz to hit petahertz. Simply, they are too distant
• Even using harmonics, it is impossible to have such a power to go from a megahertz to petahertz (1 MHz is 0.000000001 PHz). Thus, we can exclude any form of resonance.
ANYONE CAN CONDUCT THIER OWN EXPREMENTS WITH BACTERIA
Use yogurt it has lots of safe bacteria.
GATING
Gating was used to shape the RF or high radio frequency sine wave waveform so that it had a high potential voltage rise on the leading edge. Sine waves do not have an instantaneous rise like a damped wave or a square wave. They rise like the rolling waves on an ocean. The original sine wave waveform was shaped into a damped waveform by using a single audio frequency of about 1330 Hertz.
So gating in the original equipment was only used to shape the sine wave waveform into a damped wave or a square wave waveform. Today gating is not used to shape the waveform as in the original equipment but it is used to add an additional pulse to the waveform by turning the waveform ON and OFF.
DIFFERENT FREQUENCY POSSIBILITIES
Most of the frequencies are divided into several sets.
The first frequency set in an entry consists of the main numbers that experimenters find useful for that condition. In addition, frequencies associated with particular researchers are usually considered primary.
A second frequency set (if applicable) is for related frequencies, often related to co-infections.
A third frequency set (if applicable) is for frequencies that might or might not be related, depending on your particular condition.
EXPLANATORY TEXT IN EACH ENTRY
Each entry (a complete entry, not a re-direct line) contains many possible names for a condition, a description of symptoms, and the frequencies that eliminate or manage the symptom picture. Many entries also summarize how the pathogen is transmitted, and suggest therapies that complement rife sessions.
WHAT THE NUMBERS AND SYMBOLS MEAN
Hertz. If a frequency contains only numerals, without any periods or commas, it is in Hz (hertz).
Decimals. Some frequencies contain one, two, and sometimes even three decimal places. Decimals are very important; so if your unit can handle them, use them. If your unit cannot handle decimals, program a sweep to make sure that the number you need is included. For example, if your unit can do 9 or 10 but not 9.6, program a sweep from 9 to 10 so that 9.6 will be covered. Allow extra time for this sweep to ensure that you have received enough time on 9.6.
When a “K” is after a number. “K” stands for Kilohertz. Kilohertz means “thousands of hertz.” So, a “K” after a number stands for three zeros, or 000.
When a comma (,) is present. Unless semicolons are present (see below), commas after the numbers serve to separate the frequencies and make each number distinct. The commas are not part of any number.
When a semicolon (;) is present. Occasionally, a semicolon appears after the numbers. A semicolon serves to separate one frequency from the next. Semicolons are used when the frequencies are in very high ranges and extend for seven digits or more, making it necessary to use commas within one frequency to make it easier to read.
When a plus sign (+) is present. Sometimes a plus sign connects several numbers. Plus signs are used to designate frequencies that either represent microbes known to be in the same pleomorphic family, or body functions that work together. In both cases, all numbers connected by a plus sign need to be run in the same session.
LENGTH OF TIME FOR EACH FREQUENCY
The default amount of time for each frequency is 3 minutes, unless otherwise specified. However, each user has different needs, and different units have varying degrees of power. Therefore, you may need more or less time. So you will need to experiment.
Any specific disease located in any number of people may be subjected to the devitalization process with the same number of frequencies, the same number of times, the same length of time (in minutes), and with the same degree of regularity and yet each person may respond differently than every other person as to length of time required for recovery, relief of pain, toxin reaction, etc.
The reason for this is that the chemical imbalance which causes diseases to occur differs in its degree of abnormality in each individual. There are other factors involved also including the general health of each individual, the amount of rest and proper food he has, the amount of tension and worry - or the lack of it - he is subjected to during this period, the amount of medication he is taking (and the possible weakening or devitalizing effect it may be having on the body), the amount of supplemental vitamins, minerals, and proteins he is taking (if any), and other factors. All these differ with each individual.
Therefore, if one should find that the favorable reaction and recuperation or recovery is "slower" in his particular case than in some other similar case with which he is familiar, it should not be a cause for alarm. This is a situation which occurs also in the case of medical treatment, chiropractic, osteopathy, physical therapy, etc.
Always keep in mind that numerous factors are involved in each specific case; and therefore, each case will respond differently. These combined factors constitute the very reason that specific results cannot be guaranteed from the use of the Rife Frequency Instrument just as a medical doctor or member of one of the above-mentioned healing arts cannot GUARANTEE specific results from their form of treatment.
The devitalization frequency types usually cover a greater area of the body and affect the blood stream more seriously. The "load" placed on the lymph system in these types is much greater, as a rule, due to (a) a greater quantity of devitalized micro-organisms and (b) a greater quantity of toxins.
Because the lymph system must carry off the devitalized micro-organisms and toxins, it must be given a three-day period instead of just one day before the instrument is used again for the same disease or abnormal condition.
If this devitalization process was employed more often than every three days, the lymph system could become "over loaded" with devitalized micro-organisms and toxins and the result would be an undue amount of pain; therefore, sufficient time must be allowed to "clear" the lymph system between these devitalization processes. [Many people are able to treat these conditions every two days (instead of every three days) if they do not have any adverse "overload" reactions. So each person will have to evaluate their own situation].
It is important to realize that once a series of treatments has been started it should be continued with faithful regularity. This is essential due to the fact that the frequencies emitted from the Instrument are trained on the cell of the micro-organism and can devitalize these destructive agents when they have reached that particular stage, BUT these frequencies are not trained on the chemical stage of development which takes place within the body that brings into being these premodal cells. Therefore, because "the causative agents of disease" are continually going from one stage of development to another and only the one stage is affected by the Instrument, the Instrument must be used regularly until all chemical imbalance (pertaining to the specific condition you are attempting to correct) is normalized. [Those with cancer need to understand that even if they eventually get a clean bill of health they will always be susceptible to this disease and should always do a maintenance treatment at least once a week for the rest of their lives or the disease may return].
It is significant also that the blood stream, as well as the cells, of the body have been contaminated with the "causative agents of disease," therefore, the use of the Instrument on schedule is essential to (a) help to build the cells and (b) to clean the blood stream.
It is obvious, then, that the regularity of the treatment is a very important determining factor in the length of time required to completely devitalize the "current" cause of a specific disease or condition.
The following are the determining factors for the length of time suggested for applying the anode and cathode to the body.
When the distance between the anode and the cathode is nine inches or less, apply the anode and cathode for three minutes for each frequency.
When the distance between the anode and cathode is more than nine inches, apply the anode cathode for five minutes for each frequency.
The function of the Instrument is to devitalize the causative agents of certain diseases and conditions.
Time, Nature and the body must do the rest.
THINKING HOLISTICALLY
Approaching illness—and wellness—with a holistic mindset
FREQUENCY SWEEPS
FREQUENCIES SWEEPSUsing a fixed RF carrier frequency modulated with audio frequencies. Through the use of these audio frequencies which are modulated onto this RF carrier frequency, high frequency harmonic sidebands are created thus able to produce all of Dr. Rife's frequencies, through harmonic sideband frequencies, The audio frequencies ranged from 1,200 Hertz to 21,275 Hertz.
Every frequency of any organism that ranges from about 40,000 Hertz to 1,800,000 Hertz (1.8 MHz) could be multiplied up so that it would be within the range of this RF sweep. it would hit every one of Dr. Rife’s frequencies for the various micro-organisms. This sweep would also hit the frequency of any organism that was between about 40,000 Hertz to 1,800,000 Hertz. Since we know that the smallest of these organisms was the B.X cancer virus and it had the highest frequency (1,607,450 Hertz), it is reasonable to assume that all the rest of these organisms’ frequencies would be covered in this sweep. Also there are many organisms’ frequencies that have never been discovered but if they are somewhere between about 40,000 Hertz and 1.8 MHz (1,800,000 Hertz) then this sweep could with the use of other carrier frequencies also cover those frequencies.If this sweep is done over a period of 2 hours starting with 1 Hertz and going to 40,000 Hertz it would be on an organism’s window of vulnerability for about three minutes. Because the instrument can produce nearly one hundred harmonic sidebands it could hit each organism’s frequency over 20 times during this sweep.
With A square wave the harmonics from the square wave waveform will ride with or be distributed throughout the sidebands. If a 50% duty cycle is used you will only get odd harmonics from the square wave waveform but if a duty cycle greater than 50% is use, like 60%, both odd and even harmonics are created).
The theory of finding DNA or RNA-related frequencies was first developed in 1999. It considers a nucleic acid chain as an basic antenna, and then computes a frequency for it using principles of biophysics, and the coherent electromagnetic response characteristics of the entire human body. Initial in-vivo experiments with the method focused primarily on entire genomes of certain pathogens, and produced enough encouraging results to warrant further pursuit of the concept. However, because the genomes of some organisms in the course of their existence delete or acquire stretches of DNA (or RNA), it was realized that in such situations, additional knowledge from the field of molecular biology had to be incorporated into the application of this theory. If an organism with a relatively large genome acquires (or deletes) a short section of DNA, or experiences a small point mutation, it will not affect the final frequency result very much, if at all. On the other hand, if a small genome similar to for example certain cancer viruses, acquires a stretch of the host DNA or RNA, this could produce a radical change in the final frequency computation.
After the early experimental results addressing consistent-form full genomes started coming in, we also discovered a beneficial in-vivo response when applying the mathematical process to certain other very common components of pathogens. The research into this aspect of the theory is ongoing at this time, as is development of additional extensions of the method, which is under patent-pending status.