This is the basic blank for my CO2 car with smart dimensions, axle holes, and base before I make any more cuts.

Here I added the cartridge hole.

This is the final blank after I chnaged the material.

Here I am adding the windshield cutout.

This is the finished body with all of the fillets and colors. 

I offset the edges of the Cockpit Loft.

I used a circular pattern to spread the cut evenly around the wheel. 

Here I added a circle and extruded it. Then I added a dome on top of the extruded circle. 

I used the circular pattern with the domes, filleted all the sides, and then changed the material to chrome stainless steel. 

This is the sketch for the front tire.

This is the finished tire after I revolve the sketch and change the material. 

I put both the front rim and the front tire in an assembly file.

I mated the two parts together and checked it was flush.

I rotated the assembly to see if it was also flush on the back.

I sketched another circle, but extruded it this time and added a dome on top of it. 

I used the circular pattern to add the domes all the way around and spaced equally.

Finally, I filleted everything and changed the material.

The material got changed .

The tire is finished after I changed the words to white.

I made a construction circle and split it in half. Then, wrote the words on the tires and changed the fonts.

I mated the rim and the tire together.

I spun it all the way around to make sure it is flush.

I saved the file again to make a rear axle, and changed the length.

I filleted the edges.

I changed the material.

I drew two circles and smart dimensioned them.

I extruded it using a mid plane.

I changed the material to brass.