Embedded Files
Introduction
Introduction
Test Description: Test the interface with LISSA thruster module.
Completed:
Documented by: Riley Sweeney
Resources Required:
Tools: Required tools such as cleaning equipment, chemicals, jigs, hand tools, etc.
Hardware and Equipment: Iris part IDs that will be used in this test.
PPE: FM testing will likely occur in the clean room. Please follow all clean room safety guidelines. Please wear an ESD bracelet and use ESD mat when working with electronics.
Verification Activities: Provide a list of all verification activities that will be verified by the end of this test. It can be more than one if this is a multi-step test.
Pass Criteria: Provide a description of pass/fail criteria for each verification activity, including acceptance tolerances.
Test Apparatus
Test Apparatus
Provide a description of the test apparatus that will be used, and the process to install the test article. This is particularly important for Vibration and TVAC activities.
1) Step 1
2) Step 2
3) Step 3
a) Sub-step a
b) Sub-step b
Figure 1: Example Figure
Figure 2: Example step image
Test Set-Up
Test Set-Up
Provide step-by-step instructions for additional activities needed before beginning the test. This could include preparing software, data storage folders, or installing sensors.
1) Step 1
2) Step 2
3) Step 3
a) Sub-step a
b) Sub-step b
Test Procedures
Test Procedures
Provide an step-by-step instructions for completing the test, including data logging, inspection activities, etc.
1) Step 1
2) Step 2
3) Step 3
a) Sub-step a
b) Sub-step b
Test Close-Out
Test Close-Out
Include information about apparatus tear down, clean up, consumables storage, and how to store test data.
1) Step 1
2) Step 2
3) Step 3
a) Sub-step a
b) Sub-step b
Data Analysis
Data Analysis
Provide step-by-step instructions for data analysis, including location of data storage.
1) Step 1
2) Step 2
3) Step 3
a) Sub-step a
b) Sub-step b
Page updated
Google Sites
Report abuse