Collets
Unlike the smaller B2 lathe, the Pittler C3 did not come with included drawbars, a tailstock barrel bored right through and with a drawbar was also an additional cost for the C3. For Lathes fitted without a tailstock drawbar facility there is only a short (as yet unknown) taper to accept a centre, the remainder of the barrel is solid.
The mandrel drawbar is intended to accept collets with a 15mm diameter and 13mm thread. The mandrel needs an insert at both ends in order to fit the drawbar and collet. On the left-hand side of the mandrel fits an adapter and the drawbar is then inserted into it to hold it in the centre, it can be seen in the photo below. A special taper sleeve fits in the front of the mandrel to hold the collet. The mandrel can also accept Morse taper 2 collets via an insert but would need a different drawbar. I have around 40 collets, some made by Boley and others are Crawford in both metric and imperial, The same collets fit the Pittler C3 drilling spindle and milling head.
The drawbar and 15mm collets for the Pittler C3, Both Boley & Crawford collets fit the insert sleeve shown on the right
The tapered insert sleeve for 15mm Boley or Crawford collets