1/24 ScaleAuto Class Rules

Revision date: 01.12.2015

• Any ScaleAuto brand 1/24 steel chassis and plastic body may be used.

• Front chassis and body must have a MINIMUM of .032” clearance, measured under the entire car. The car must sit on tires on tech block. (guide flag not touching) gauge must slide under without lifting front tires from tech block.

• Rear chassis must have .062” clearance, measured under the rear axle. The car must sit on the tech block, guide flag not touching, gauge must slide under the rear chassis without lifting rear tires from tech block.

• Front & Rear wheel track width = TBT

• Any guide flag may be used.

• Motor: STOCK SC-0026 Scaleauto Long Can Endurance Motor, 22.000rpm Endurance-1 ONLY

• Drive: STOCK Angle-Winder ONLY

• Gears: STOCK 12/44 ONLY

• Front Tires: STOCK rubber or foam

• Rear Tires: ScaleAuto SC-2421p ProComp-3 for 3mm Axle 27.5x13 mm /21 mm wheel 

• We may switch to ProTrack Tires after the first set wears out.

• When you plan to buy a car make sure that the livery is NOT already being raced!  Two of the same liveries on the track is HIGHLY discouraged!!!

Liveries taken:

Dave's Car:

Bob's Car:

Jeff's Car:

ZoMaxx:

Dan's Car:

Bruce's car:

Bruce's car:

Andy's Car:

Darrell's Car: