1/32 Modern Class Rules

Revision date: 12.21.2022

• Any brand 1/32 plastic chassis and body may be used that's NOT Group C or Group 5.

• Front chassis and body must have a MINIMUM of .015” clearance, measured under the entire car. The car must sit on tires on tech block. (guide flag not touching) gauge must slide under without lifting front tires from tech block.

• Rear chassis and body must have a MINIMUM of .032” clearance, measured under the rear axle.

• Front & Rear wheel track width = 2.5” max

• Any guide flag may be used.

• Motor: ANY

• Body: Any hard plastic body.

• Drive: In-line, Side-Winder, or Angle-Winder.

• Gears: ANYTHING.

• Front Tires : Stock rubber or foam 

• Rear Tires: Purchased ONLY at the track

  • 0.790" Dia: JKT7S3W (Formally 8702PPW) or JKT7M3W (Formally JK-8712PPW)

  • 0.820" Dia: JKT9S3W (Formally JK-8703PPW) or JKT9M3W (Formally JK-8713PPW)

• Break-out time rule: You can drive as fast as you wish, but laps faster than 4.750 seconds will not count. 

IF you can break-out, with an IN-LINE drive Modified car, I buy dinner!