1/32 Trans Am Rules

Revision date: 12.08.2023 

• Any 1/32 plastic chassis and body.

• Front chassis and body must have a MINIMUM of .015” clearance, measured under the entire car. The car must sit on tires on tech block. (guide flag not touching) gauge must slide under without lifting front tires from tech block.

• Rear chassis and body must have a MINIMUM of .032” clearance, measured under the rear axle.

• Front & Rear wheel track width = 2.5” max

• Driver: Stock interior would be nice but Lexan is ok.

• Front Tires: Rubber or foam 

• Rear Tires: Purchased ONLY at the track

  • 0.790" Dia: JKT7S3W (Formally 8702PPW) or JKT7M3W (Formally JK-8712PPW)

  • 0.820" Dia: JKT9S3W (Formally JK-8703PPW) or JKT9M3W (Formally JK-8713PPW)