1/32 Grp C/5 - DP Rules

Revision date: 12.21.2022 

• Any Slot.it or Racers-Sideways brand Group C, Group 5 or Daytona Prototype - 1/32 plastic chassis and body shown below.

• Front chassis and body must have a MINIMUM of .015” clearance, measured under the entire car. The car must sit on tires on tech block. (guide flag not touching) gauge must slide under without lifting front tires from tech block.

• Rear chassis and body must have a MINIMUM of .032” clearance, measured under the rear axle.

• Front & Rear wheel track width = 2.5” max

• Driver: Stock interior would be nice but Lexan is ok.

• Motor: Slot.it SIMN09CH Motor Low Profile Boxer FLAT6 20,500 RPM Open / Closed Can

• Drive: Anglewinder 

• Gears: Largest Pinion = 13 teeth - Spur Gears 26, 27, or 28

• Front Tires: Stock rubber or foam 

• Rear Tires: Purchased ONLY at the track

  • 0.790" Dia: JKT7S3W (Formally 8702PPW) or JKT7M3W (Formally JK-8712PPW)

  • 0.820" Dia: JKT9S3W (Formally JK-8703PPW) or JKT9M3W (Formally JK-8713PPW)

• Break-out time rule: You can drive as fast as you wish, but laps faster than 4.750 seconds will not count.