Night 12 (2/22/16) page 47

Post date: Feb 23, 2016 6:18:02 AM

A bit of frustration getting the heated bed up to temperature. The bed would get close then the RAMBO fan would come on and drop the bed temperature 7 degrees C. PID calibration was a bust, but I found someone who taped aluminum foil to the bottom of the heat bed mounting plate and the top of the base. This worked for tonight and I have an email in to SeeMeCNC support to make sure that I’m not going to hurt anything over the long term.

Below is the successful print of the layer fan shroud.