Tedd's lil-Jeep

This is a project that I have taken on for myself just to gain more practice and familiarity with fusion360 and prusaslicer.

I own a 2007 Jeep Wrangler and have always been into Jeeps. This project is based loosely off of a Willies CJ2a. My plan for this project is to modify and improve this model throughout my time in the CAD class I am taking.

The Print This is the most complex and longest print I have done yet. I fiddled with the settings within PrusaSlicer hoping for high definition and strength. This print was forcasted to take over 8 hours so I started it and let it run over night with out any supervision. This may have been a mistake as one of the wheel's didn't print properly and has a hole. regardless though the print turned out very pretty IMO.

I plan to fiddle with the design a bit print this again.

If you would like a Lil Jeep, drop me an email and I'll try to make it happen!