LT4320 based CRC PSU PCB from following thread
https://www.diyaudio.com/community/threads/lt4320-based-active-rectifier.336572/
Mosfets
SUP70060E-GE3 $32 for 16 150 stock 100v, 131A, 4.8 mohm
A 1μF ceramic and a 10μF minimum electrolytic capacitor must be placed across the OUTP and OUTN pins with the 1µF ceramic placed as close to the LT4320 as possible.
Parts
584LT4320HN81#PBF U2 Bridge Controller
78SUP70060EGE3 Q1-Q4 Mosfet
505MKS2D041001K00MS C2, C3 Film Cap 1uf, 100v
75517D106M100AA6AE3 C1, C4 Electro Cap, 10uf, 100v
0.15 uf =150 nf wima cap CS1, CS
15 ohm RS1, RS quasi reading 14 ohms, 15 was closest value
0.01 uf = 10nf CX1, CX from junk drawer
Hammond 156B 1.5mH, 5A, 70 mohms 2.81 long x 1.50 wide x 1.69 tall
2.38 hole to hole About $20 each
I used a quasimodo fixture to determine the values to use for CX, CS and RS to shunt the transformer secondaries
I have the surface mount version, where C3 (CS or cap in series with resistor) = 0.15 uf
It is soldered in.
CX is recommended to be 0.01 uf. But you can change and try different values.
Using
Connect transformer secondary to tx connector (screw down wires)
Short out all primaries together, and other secondary. For a dual independent secondary supply.
If secondaries are in series or parallel, connect them same way for measuring.
Connection for center tapped
Connect scope to output
Pot should be inserted with screw toward middle of board. Insert CX/C2 that you plan to use.
Set scope for 1 usec/div timebase and 1 V/Div amplitude
Set pot to full clockwise (max R)
Plug in Quasi, and find ringing
Turn pot counterclockwise until ringing lowers
Continue until third peak is flat. Turn off Quasi, remove and measure pot (middle lead and lead under screw)
First peak is short, 2nd peak is full waveform.
https://www.mouser.com/ProductDetail/595-TLC555CDR U1
https://www.mouser.com/ProductDetail/942-IRF8721TRPBF U2
https://www.mouser.com/ProductDetail/579-TC4426COA U3
https://www.mouser.com/ProductDetail/833-BAT750-TP D1
https://www.mouser.com/ProductDetail/604-APT3216MGC D2
https://www.mouser.com/ProductDetail/652-3296W-1-102LF POT
https://www.mouser.com/ProductDetail/710-885012208088 All other C's
https://www.mouser.com/ProductDetail/667-EEE-FK1V221GV C12
https://www.mouser.com/ProductDetail/594-K103Z15Y5VE5TH5 CX (C2)
https://www.mouser.com/ProductDetail/660-RK73B2BTTDD472J R1
https://www.mouser.com/ProductDetail/652-CR1206JW-393ELF R2
https://www.mouser.com/ProductDetail/652-CR1206FX-8250ELF R3
Power Supply was an 8V walwart I had in my junk drawer. Can use anything between 2.7 and 18 VDC