FOAM MODELINGÂ
In this lesson I started working on my foam model to test if my final product would work or not. First sketch the mosquito coil holder onto a piece of paper to later be cut out and stuck onto a foam. Afterward I pushed to cut around the shape of the foam using a heated thin piece of metal. Later on I use a heated rod to burned a hole through my foam model this is because I need to cut a whole for where my mosquito coil is going to be shown.
I then inserted a hacksaw in to one of the hole and slowly make my way toward another whole. After finishing one of the sections that goes all the way through my mosquito coil I have to remove the saw blade from the whole and into another hole for another section to be cut out.