Embedded Files
Make sure to always follow these safety guidelines to avoid getting in trouble!
Make sure to always follow these safety guidelines to avoid getting in trouble!
- Put on goggles when any machine is in use
- Tie hair back
- Just ask Mr. Solin or Ms. Woz for a hair tie
- Tuck your IDs in
EStop
EStop
FOR EMERGENCIES ONLY: Estop (Emergency Stop, see picture below) is the red dial. Push dial down to activate, turn clockwise to release. Only use it in the event of:
- Machine is shaking
- Machine is drilling into the board and not into your material
- Machine is overheating
- Drill bit is breaking off or has already broken off
- Or any other mechanical difficulties you see occurring
NOTE: If your design is not turning out the way you wanted to, or you did not center the material correctly, this is NOT an emergency. Just press the pause button on easel to stop the machine from running.
NOTE: These are NOT toys. These machines cost a lot of money, so do not misbehave around them.
Report abuse