Steps to mount the camera:
01. Avoid dust in the optical system and don't touch the camera sensor or any lens with your fingers!
02. If the trinocular head of the microscope has a light path selector, set it to send 100% of the light to the eyepieces
03. Remove the camera adapter from the microscope
04. Remove the old camera from the camera adapter
05. Hold the camera in a way that the sensor is always pointing towards the desk (no dust can fall onto the sensor)
06. While the new camera is pointing downwards, too, remove the dust cap from the new camera and mount the cap on the old camera to protect it
07. Attach the new camera to the camera adapter
08. Attach the camera adapter to the microscope
09. try to adjust the camera to be parallel to the motion of the stage
Watch these videos on how to attach a camera to a microscope.
Then, continue with Install Software
Orientation of Basler Cameras (Attention: If you want to move the image on the screen in the same directions like when you are looking at the slide via eyepieces, you have to ROTATE the camera by 180 degrees compared to the picture shown below):
Continue with Install Software