BASIC OVEN FAULT CODES

Oven/Ranges/Stoves

--------------------------------------------------------------------------------

GE / Hotpoint / RCA

Oven Fault Codes

Display Condition Remedy

F0 & F1 Failed Thermistor Control Replace ERC

F2 Oven Temp Exceeds 590 with unlocked door High resistance in Sensor, likely a bad sensor

F3 Open Sensor circuit Open (blown) sensor fuse or bad Sensor

F4 Shorted wire or Sensor locate short and correct it

F7-A Function pad button stuck Clean and unstick

F7-B Bad Clock Replace Clock

F8 Electrical component failure Replace ERC

F9 Program with door circuit Check wiring

Frigidaire / Westinghouse / Tappan / Gibson

Oven Fault Codes

Display Condition Remedy

F0 & F1 EOC failure Replace EOC

F2 Oven over heat Defective Sensor or EOC

F3 Oven Sensor Open Replace Sensor

F4 Shorted wire or Sensor locate short and correct it

F5 EOC failure Replace EOC

F6 EOC failure Replace EOC

F7 EOC failure Replace EOC

Maytag / MAYCOR / Magic Chef / Jennair / Admiral

Oven Fault Codes

Display Condition Remedy

F0 Function key shorted or stuck button Clean and unstick button or replace Touch Pad or Clock

F1 Defective Touch Pad or Membrane Replace Touch Pad or Membrane

F2 Oven over heat defective Relay Board or (if present) or defective Sensor

F3 Oven Sensor Open Replace Sensor

F4 Shorted wire or Sensor locate short and correct it or replace Sensor

F5 Hardware, safety circuits disagree Replace Clock

F6 Missing AC (power) signal Check for proper voltage (plug, breaker, etc.)

F7 Function key shorted or stuck button Clean and unstick button or replace Touch Pad or Clock

F8 A/D Warning Replace Clock

F9 Door Lock Warning Check door lock circuit or Replace Clock

Amana / Caloric

Oven Fault Codes

Type with display - glass link ERC

Display Condition Remedy

F0 No Safety Signal Replace adapter board

F1 No Safety Signal Replace ERC

F2 Oven over heat Replace defective Sensor

F3 Oven Sensor Open Replace Sensor

F4 Shorted wire or Sensor locate short and correct it or replace Sensor

F7 Shorted Touch Panel Replace Glass Panel

F9 Door Latch Error Check latch

FF Lock Error Check switch and motor

ERC III - Relay board with separate board/push buttons

F0 Shorted Push Pad Replace Push Pad

F1 Defective ERC Replace ERC

F2 Oven over heat Replace defective Sensor

F3 Oven Sensor Open Check/Replace Sensor

F4 Shorted wire or Sensor locate short and correct it or replace Sensor

F5 Defective ERC Replace ERC

F6 Defective ERC Replace ERC

F7 Shorted or sticking button Clean button or replace touch pad

F8 Defective ERC Replace ERC

F9 Door Latch Error Check latch

The following diagnostic chart Does not apply to Whirlpool 'Y' line products. If the model number contains a Y near the end of the number, DO NOT use this chart.

Whirlpool / KitchenAid / Roper

Oven Fault Codes

Ovens with 4 digit displays

Display Condition Remedy

F0-E0 Analog to Digital failure Disconnect panel for 30 seconds. if error re-appears then replace control

F1-E1 Defective ERC Replace ERC

F2-E0 Shorted Keypad Replace Keypad

F3-E0 Sensor or Sensor Fuse Open Replace Sensor or Fuse

F3-E1 Shorted wire or Sensor locate short and correct it or replace Sensor

F3-E2 Oven over heat Replace Sensor

F3-E3 Cleaning Temp over heat Replace Sensor

F5-E0 Door Error Check Door

F5-E1 Door Latch Check Latch

F5-E2 Door Switch Check Switch

Ovens with 2 Digit Displays

F0 Defective ERC Replace ERC

F1 Defective ERC Replace ERC

F2 Oven over heat Replace defective Sensor

F3 Oven Sensor Open Check/Replace Sensor

F4 Shorted wire or Sensor locate short and correct it or replace Sensor

F5 Defective ERC Replace ERC

F6 Problem with time keeping circuit Reset Time or cooking operation and check for proper ground

F7 Shorted or sticking button Clean button or replace ERC

F8 Defective ERC Replace ERC

F9 Door Latch Error Check latch and latch circuit