DOT DRYER NOTES

This dryer by the way cannot be accessed from the

rear at all. You pop the bottom flap spring clips to access the heater and limits.

The idea being convenience of maintenance.

This dryer has more than one fuse.

Note the location of the various fuses. Some folk call this the DOT dryer.

Dryer of tomorrow. I call it the P. I .T .A. dryer. Go figure.

To get inside this one you flip the controls like a direct drive top load washer

You remove 3 hex head screws and slide the top towards you.

You back off or remove some screws below the door, remove the door springs

and then remove the screws up top that hold the inner panel to the frame.

This dryer has 4 wheels, 2 in front and 2 in back. The Idler is located to the

 left and has to be routed blind with your arms.

This dryer has a moisture sensing wire that attaches right beside the filter.

 It pays to know this because inevitably that dang wire will be a

 problem if you do not make a note of where it goes when removing the front.

Here is a DOT dryer manual that features moisture sensing control.

Late model TECH SHEET FROM PC DRIVEN dryer with dot characteristics