Cu CMP for BEOL damascene interconnects :
non-azole corrosion inhibitors in the slurry
Cu CMP is a key step in the BEOL damascene process, removing the Cu overburden so that only the Cu inside the trenches remains as the interconnect.
Since CMP is applied to patterned wafers, the polished surface must stay flat without dishing or erosion of the Cu lines.
The corrosion inhibitor in the slurry protects the Cu surface from excessive dissolution, balancing removal rate and planarity.
Non-azole inhibitors are therefore being studied as alternatives to conventional azole-based inhibitors, which raise toxicity and post-CMP residue concerns.
Mo wet etching for advanced logic and memory devices
Mo is a promising metal for advanced semiconductor devices due to its electrical and thermal properties.
However, precise Mo wet etching remains challenging because of its complex oxidation and dissolution behavior.
These reactions can lead to non-uniform etching, surface roughness, and uncontrolled removal.
The type of oxidizer significantly influences the oxidation and dissolution behavior of Mo.
To address these challenges, we are investigating the oxidation and dissolution mechanisms of Mo to develop a precisely controlled wet etching process.
Cu wet atomic layer etching for Cu hybrid bonding
As semiconductor devices become increasingly integrated, Cu hybrid bonding is being developed as a promising technology for three-dimensional (3D) semiconductor integration, enabling fine-pitch interconnections.
For reliable Cu hybrid bonding, precise control of Cu recess depth and surface roughness is essential to ensure high-quality bonding interfaces.
Conventional chemical mechanical polishing (CMP) is widely used for surface planarization, but precise control of Cu recess depth remains challenging.
Therefore, wet atomic layer etching (ALE) of Cu is being investigated as a promising approach for precise Cu recess control with high selectivity over surrounding dielectric materials, such as SiO₂ and SiCN.
To achieve this, various activation agents and dissolution agents are being studied to optimize Cu removal behavior and etching conditions.