Overview

This page covers all of the DMR controls that can be found in the control room.

Primary Control Desk

Ignition Button

This button initiates the startup procedure once all fuel cells have been locked, and the catalyzer feedwater pumps are enabled. The Laser Calibration Feature is planned to be brought back but is not required for Start Up as of now.

Alarm Monitoring

Shows a display of the currently active alarms, and an option to mute them temporarily.

Monitoring Control Desk

Shutdown Console

Main page: Emergency reactor shutdown

An emergency shutdown system, in the event of a thermal runaway of the DMR. The panel is protected by a code and two keys to prevent accidental activation.

Shift Manager

This panel shows the current tier of the nightshift, with points ranging from 0 to 100. It also shows the DMR's current power orders. In the event of a thermal runaway, this display will show the shutdown code.

Chamber Airlock

This panel shows the current status of the airlock. The reactor chamber access door can be closed by security using this panel.

Thermal Regulation Desk

Catalyzer Circulation Control

This panel shows the status of the Pump Station Alpha pumps, and the temperature and efficiency of each catalyser. The amount of coolant distributed to each power laser can be controlled with a button panel. The outlets of Pump Station Alpha and the catalyser reactor feedwater loops can be controlled here.

Not to be confused with superstructure circulation control.

Superstructure Circulation Control

This panel shows the status of the Internal Cooling Pumps. The amount of coolant distributed to the DMR can the controlled with a button panel. The outlets of the External Circulation Pumps and the regenerator units can be controlled here.

Emergency Fire Suppression System

This panel shows the status of the E.F.S.S. and how filled the water tanks are. The E.F.S.S. can be manually activated by Corporate+, but also automatically activates after a successful reactor shutdown.

Pressure Relief

This panel shows the status of the pressure relief valves. The toggles can be used to activate the relief valves when the DMR temperature is above 1200K. Activating a pressure relief valve decreases the DMR's temperature but increases radiation levels in the chamber. The pressure relief valves can reach a thermal cap of up to 60%, before they need to cool down for 60 seconds.

Circulation Overview

This panel shows the status of the Internal Cooling Pumps. No controls are available.

Grid Management Desk

Global Catalyzer Control

This panel has a button panel to control the intensity of all catalyzers at once. The higher the level, the less the control rods of the catalyzers are inserted. This panel can only be used when the catalyzer control mode is set to global.

Catalyzer Monitoring

This panel has a display showing the intensity of each catalyzer. The catalyser control mode can be changed with a switch between global and fine. This is where the catalyser feedwater loops can be enabled.

Fine Catalyzer Control

This panel has six levers to control the intensity of each catalyzer individually. The higher the level, the less the control rods of the catalyzers are inserted. This panel can only be used when the catalyzer control mode is set to fine.

Electrical Systems Overview

This panel shows the status and fuel of each generator. No controls are available.

Local Grid Overview

This panel shows the status, RPM, and energy output of each turbine, along with the hourly production rate. No controls are available.

Maintenance Overview

This panel shows the fuel type and amount for each fuel cell. Maintenance mode can be engaged when the fuel level is less than 20% by flipping both keys and pressing the button. Once maintenance is complete, the button can be pressed again to exit maintenance mode.