The oiling system is made up of numerous components. There is an internal high pressure pump that feeds all the oil galleries and oil jets within the engine. The stock system has a pickup that is submersed in a constant oil bath within the oil pan. The pump pulls the oil up from the pan and pressurizes it to up to 90 PSI for use within the engine.
The internal system within the engine is as follows (see subheading picture). The oil is picked up through the oil strainer by the oil pump. This pump them pressurizes it and sends it to the pressure relief valve (PRV) to vent any excess pressure (90 PSI max). After this the oil goes through the oil filter from the outside to the inside of the filter cartridge then to the oil cooler. After being cooled the oil moves up to the crank shaft and lubricates the main journal bearings and fires oil through the oil jets. At the end of the crank there is a engine oil pressure switch (EOP) which monitors the oil pressure and shits the engine off in the case of a low oil pressure situation. After this point the oil moves up to the cam shafts (two in this case) and lubricates the bearings at the top of the engine. Throughout this whole process all oil that leaves the galleries through the jets, bearings and relief valve flow back down the sides of the engine back into the pan.
The CBR600RR engine uses the same oil for the engine and transmission. This is fed by the same oil pump that is used to supply the engine with oil. The oil is diverted to the transmission and oil jets spray the gears. It then goes to the main shaft, countershaft and clutch disks of the transmission. Oil then drains from the transmission pan back to the main oil pan.
The oil cooler is a water-oil cooler. This means that it takes the water that is used to cool the engine block and uses it to cool the oil as well. The oil enters the cooler from the outside and returns through a specially made fastener in the center. The water runs through the external pipes to a jacket that keeps it separated from the oil that is surrounding it.
Oil Jets are used to cool and lubricate the pistons. They are fired from below and spray up onto the backside of the piston and cylinder walls.
The oil pressure relief valve is put in the oil system to prevent an overpressure situation within the engine. It is a spring activated check valve that actuates when the oil pressure on the valve meets or exceeds the maximum pressure that you have it set to (90 PSI in the case of the CBR600RR).
Our team has taken the original wet sump system from the CBR600 and changed it to be a dry sump system. This allows us to lower the engine in the car as it is a much lower profile than an wet sump system. This helps us bring the center of gravity (CG) down closer to the ground which improves roll stability. Another reason we use a dry sump is due to the high lateral cornering forces that come from the car. When the car is cornering at high speeds the oil sloshes up the side of the wet sump. This can lead to oil starvation issues. A dry sump system stores the oil in an external reservoir. This tank is often baffled preventing some of the sloshing issues. The oil is then picked up from the tank and taken to the engine where it follows the standard engine oiling scheme as outlined above.
Some downsides of having a dry sump is that you need to design a pan that will allow you to pickup the oil and you need to run a secondary "scavenge" oil pump to pull the oil out of the dry sump pan.