My proudest work, even more than my first born child, the bevel box! An invention as old as mankind's desire to harness the breeze reinvented with UBCOMOTORSPORTS MKII.2!
Now, an important consideration when designing the bevel box, is considering how you will mount/interface with the steering rack. Depending on what way you need to turn the pinion gear will dictate which side of the upright shaft you place the horizontal bevel gear. Note the diagram below.
This bevel box was a big improvement in accuracy and driver feel over the fabricated monstrosity. By machining the box separately I could control the gear engagement and the 90° angle better. This design is too complicated to simply discuss in a few short sentences. Download the cad and study it. If you're in the position to be reading this and using the information to design something, I trust you can draw your own conclusions as to the function of all the components. The columns were welded onto these stub shafts afterwards. I still had issues locking the gears to the shaft. I wouldn't weld it out of principle, as the design is supposed to be serviceable, but I should have just welded the gears to the shaft. If something went wrong I would just unbolt it from the car and cut off the steering columns.
Lessons learned:
You don't need to make things infinitely serviceable and modular, it just makes you feel like a rockstar.
LOCK THE FUCKING GEARS TO THE GOD DAMN SHAFTS. Seriously, this is the bane of my existence. Keyways and keys are not sufficient. Weld that shit up. Make sure you HAZ doesn't fuck up your material properties and cause failure. This is a small shaft, that heat will change the temper.
Bearings everywhere give a very nice steering feel.
This design paid a lot of attention to taking the bevel box/steering rack in and out of the car, as throughout the build cycle you will do it many many times. Make sure it isn't difficult, otherwise you will curse the engineer who designed it, who is you. Taking this in and out was easy, I am please with how quick I could remove it all.
Reduce machining where possible. Most students will not be as competent and quick in the machine shop as I was, and this took me probably 8-15 hours to build. Make it easier, make it quicker, or just buy one. They're really not a unique idea. (hence the sarcastic intro)
Though nothing changed between Rev 1 and Rev 2, I will touch on the steering rack, since I didn't before.
I selected the Sweet MFG rack for its serviceability (notice a trend here), and modularity. The pinion can be swapped to achieve different C Factors. (turns of pinion to travel of rack). Additionally, the pinion is on an eccentric bush that allows the mesh to be adjusted.
The fact that the pinion is not on the centreline of the body causes immense headache. I can't even begin to explain the complexity induced by having the body mounted off centre (or the body mounted on centreline and the pinion and thus steering wheel mounted off centreline). The only easy solution is to use the bad bad universal joints.
Additionally the rack is heavy, and much stronger than required.
Designing a new rack would not be hard, but I recommend purchasing an FSAE specific unit. This is really high weight savings/dollar.
The steering rack experience some forces axial to the pinion. I.E. some forces causing it to move up and down. The reason for these forces should be obvious, I hope. If not, do an FBD. These forces were underestimated in my design, and there is substantial movement in the rack. The rack mount should have had much better undersupports, and a large mounting footprint. Pictures below
LESSONS LEARNED:
Support the underside of the steering rack better.
Get a lighter and easier mounting steering rack
C factor was good with the size steering arm the uprights had.