Front wings are the initial contact a racecar has with the air. With it's position low to the ground, the front wing allows for a negative pressure area to be generated underneath causing an overall downforce on the car. Downforce is important because it allows the car to have a better grip on the road and allows for increased speed when going around corners.
A key component to consider when designing any type of aerodynamic part, especially the wings, are the downforce to drag ratio. A larger wing may increase your downforce tremendously but it will be at the cost of increased drag, which should be minimized to increase speeds.
Check out these links below to learn more about front wings and the aerodynamics of an FSAE Car!
Mean Camber Line - The locus of points midway between upper and lower surfaces and perpendicular to the Chord Line.
Leading Edge - The most forward point of the Mean Camber Line.
Trailing Edge - The most rearward point of the Mean Camber Line.
Chord Line - A straight line connecting Leading and Trailing Edges.
Chord - The distance between Leading and Trailing Edges.
Camber - The maximum distance between the Mean Camber Line and the Chord Line, and the measure of curvature.
Thickness - The distance between the upper and lower surfaces.
First Digit - Cmax- The maximum Camber as a percentage of the Chord.
Second Digit - XCmax - The position of the maximum Camber in tenths of the Chord.
Third Digit/Fourth Digit - Represents the maximum thickness as a percent of the Chord.
**Coefficient of lift and drag can be determined through an X-Foil simulation **
Reynolds Number (Re): Ratio of inertial forces to viscous forces in an air flow. Conventional airfoils operate optimally with a Reynolds Number of >10^6. As the value decreases, lift and drag increases ; the higher the value the less viscous the fluid is.
Mach Number (M): Ration of the speed of the object compared to the speed of sound in the fluid. The Mach number affects the compressibility effects which alters the force on the wings/vehicle.
Π= -1/γ M^2 [p] +1/Re [v]
Inertia (Π):