DYNAMIC CHECKLIST
To be performed and signed only by those authorized by current Kinematics Team Lead
DATE
I , [print name] ensure that each item on the proceeding checklist has been properly performed, and the to best of my ability and knowledge, deem
UBCO Motorsports racing vehicle safe for dynamic racing and/or testing
Initial each check as it is completed
Inboard A- arm Bolts: ____
-Correct length bolt with nylock (or tri-lobe) nut.
-Two threads showing beyond nut mandatory
-Properly tightened, no gaps between mounts and spacers
-Too tight is not a huge concern
Outboard A-arm Bolts: ____
-Correct length bolt with nylock (or tri-lobe) nut
-Two threads showing beyond nut mandatory
-Properly tightened, no gaps between mount and spacers
-Too tight will cause undue steering tension
-tighten with wheels off ground, turn wheels
Back and forth tightening until resistance to turning
Wheels is felt
Upright A-arm mounts: ____
-Ensure bolt head is outboard
-Ensure nut is nylock or tri-lobe
-Ensure proper shim stack is installed
-ensure bolts are properly torqued
-too tight will shear the ¼”-20 bolts
-torque spec necessary but currently not figured
Steering Rack Bevel Gears: ____
-Ensure both bevel gears have bolt installed
-tri lobe or nylock
-Ensure bevel gears are meshing acceptably
-Ensure bottom bearing support is installed and bolted properly
Steering Rack: ____
-Ensure rack mount bolts are installed
-Nylock (or tri-lobe) nut with two threads showing
-Properly aligned in centre of car (Vertical shaft must be vertical)
-Ensure steering shaft has bolt installed to clamp it onto the steering rack
-(nylock or tri- lobe two thread showing)
Front Bellcrank: ____
-Ensure proper bolt installed with proper washer (if required)
-Nylock or tri-lobe with two threads showing
-Check there are no bends or cracks in bellcranks
Rear Bellcrank: ____
-Ensure proper bolt installed with proper washer (if required)
-Nylock or tri-lobe with two threads showing
-check there are no bends or cracks in bellcranks
Dampers: ____
-Ensure dampening setting is properly set front and rear/side to side
-Ensure proper spacers are installed with proper bolts and nuts
-Ensure spring preload settings are consistent around car
Pull/Push Rods: ____
-Check for any dents (visually look and physically feel for dents)
-Ensure proper lengths are set (corner loads and ride height)
-Ensure lock nuts are tightened down
Brake Check: ____
-Ensure brakes have sufficient fluid in reservoirs
-With Car off ground, press brake pedal, ensure every wheel brakes
-Ensure brake light is operating properly
-Ensure brake discs each have 8 properly installed bobbins with circlip installed
-Ensure no visual cracking is taking place
-Ensure brake pads have sufficient brake pad material
-Ensure brake discs don’t have any grease on them
Pedal Box: ____
-Ensure pedal box is tightened down onto mounts
-Ensure clutch has proper free play
-Ensure gas pedal has proper stops set
-Ensure gas pedal has both return springs installed
Hubs: ____
-Ensure hubs/bearings are properly torqued
-for the untrained just ensure the wheels turn freely
but have a slight resistance to turning
-Ensure hubs do not wiggle in uprights
Tires: ____
-Ensure tires have proper inflation 12psi min (12psi-18psi operating range)
-Ensure tires have sufficient tread left and are not on wear bars