Hey looks like you're trying to get the race car to talk. If yelling isn't working this might be your best bet.
The Wireless Telemetry Project was a capstone project completed in the 2020/2021 academic year. It consisted of designing both hardware and software for a complete wireless telemetry product. This page will contain a simple summary of the project and details. For a detailed description, see the detailed design report located below or reference the project drive. Schematics, PCB designs, and all software source code can be found open source on the UBCO Motorsports Github here: https://github.com/UBCO-Motorsports/WirelessTemetryCapstone
A new iteration of the ControlBoard project was produced for this project. Changes included an STM32 microcontroller, a different SBC, and better voltage regulation. The ControlBoard was mated to the telemetry main board which acted as a simple interface between the control board and the XBEE wireless transceiver. To interface the wireless telemetry module to the car, only 4 wires are required: +12, GND, CANH and CANL.
The telemetry software was designed from the ground up using Python. It has the ability to dynamically program graphs for the received data as well as send commands back to the vehicle. (Joel insert more details here)
The embedded software running on the wireless telemetry software was developed in C using the STM32CubeIDE programming environment. It is responsible for receiving specified filtered CAN data frames and parsing them to a serial UART string which can then be read by the telemetry software. The embedded software can also parse incoming serial commands and execute them either for internal software settings or to communicate with the vehicle via CAN. A real time operating system (RTOS) was used in this project for both utilizing strong design patterns and as a learning experience to become familiar with RTOS development.
For a full list of commands that the wireless telemetry system currently supports over serial, see the spreadsheet below that can be found in the project drive.