Safety Precautions

             Mandatory Conditions to follow and observe:

●    The “UAS Is not IP rated” Please avoid using it in Drizzle/heavy wind or dusty conditions any damage under this regard will void the warranty.

●   There are “No shock absorbing” mechanisms implemented in the UAS, Avoid Harsh/Rough landings

●   No-fly zones must be observed. It is the user’s responsibility to ensure that the drone is operated legally and safely.

●   Changing any factory parameters is recorded on the flight controller and will void the warranty.

●   Be careful NOT to override the drone if it is in low battery landing mode. It is not safe to fly if the battery is LOW

●  If after calibration the craft is unsteady or toilet bowling, land the craft safely and re-do the calibration process. DO NOT calibrate near any metal or over re-enforced concrete.

●  Always wait until the props have completely stopped spinning before approaching the drone. Once landed remove the Quick switch place it on the propeller and cover the drone with the drone cover.

● Before each flight, please check the propellers for damage – replace immediately if damaged. The lithium batteries should be removed from the aircraft after each flight. When not in use, the lithium batteries should be placed in a fireproof pouch or container and stored in a cool environment to avoid accidents. Keep out of reach of children and pets.

●  Never overcharge or overcharge the LiPo battery as this will reduce the LiPo battery life or the LiPo may catch fire.

●  The lithium batteries should never be stored at full charge – the ideal level is 3.8V. Always remove the LiPo battery from the aircraft place it in a fireproof pouch and store it in a cool environment.

●  Study the LiPo voltage chart below to assist you with your battery condition checking – Use the BX100 battery checked

●  If a LiPo battery swells or is deformed – Contact MARUT Personnel Immediately!

●  Always look for a clear platform with at least 3-4m clearance from the landing spot

NOTE: Due to continuous product development and improvement, some images may differ from the final product.