Fly View
After adjusting the required parameters click on save.
It will be redirected into main screen as shown below:
On the left-hand side of the screen, the user will find the buttons that are required to control the flight such as:
Takeoff
RTL
Resume
Pause
Take-off:
To fly the drone, the user should click this button.
After selecting this button, the pre-flight checking will be done automatically.
AeroGCS GREEN allows the user to change Speed, Altitude, and spray volume here also as shown in the image below.
After editing these parameters, upload the plan and proceed for flying.
After adjusting these parameters, pre-flight check will be performed automatically which is indicated by the popup window as shown:
Wait till all the prechecks are performed and indicated by ticks in all the checkboxes.
Press ok to proceed with a flight.
Click on either pause or change mode then which will allow pausing the mission of flying due to some unavoidable circumstances or when the tank is empty.
The particular position is marked as 'R' as shown in the image below which will be used for further process.
Again reupload the mission by referring to sec01,it will ask to upload whether resume mission yes or no, click on “yes”.