Dashboard

Install App

The GCS App will be installed by the Marut personally at the time of Delivery.
Our Pilots will do the flight test with the given mobile and use the app in the mobile to avoid failure.

Know your Dashboard Icons:

Takeoff :

Once Clicked on the Takeoff command, the Arm and takeoff commands are sent to RPA.
RPA Does the pre-flight check and if everything is good and does the takeoff.

Land:

Land command enables you the RPA Land Option.
RPA slows down the flying and returns to home position.
Land commands work only when the drone has already taken off.

RTL ( Return to Launch):

RTL is used for an emergency Landing.
The drone will find the shortest distance to land at home position for a safe landing.

Pause:

The Pause command will pause the instructions to the device using RPA.
RPA will pause at the point it is flying.
The device will go into hovering mode, once pause is active it will be resume by RPA.

Resume:

The resume command will give operation to resume instructions to the RPA.
RPA will resume the flight from the point where it was paused.

Page updated

Google Sites

Report abuse