Netgear Arlo firmware updates present a lot of advantages and give revision to the Arlo system. Include repairing security holes that are discovered and eliminate bugs from the Arlo system. Arlo update firmware adds new and latest features to Arlo system setup. These updates help remove software vulnerabilities so that these system weaknesses do not benefit third parties. Arlo update protects your data from going intothe wrong hands and helps keep hackers out.

Arlo Wire-free and Arlo Pro Wire-free cameras are manufactured to get automatically updated if the Arlo base station is connected to the Arlo camera, having a minimum of 15% battery and a base station is powered on with a power supply. Due to difficult circumstances if the conditions do not meet then there will be an automatic update within 24 hours after the power supply is on, battery life is a minimum of 15% and a base station is connected to the camera. These automatic system updates take place between 3.00 a.m. – 5.00 a.m. to avoid interruption during the daytime. If the Arlo update is an essential one until the firmware is updated you might not be able to view your camera live, motion but sound detection and recording still work because of the personalized selected mode. As an exception, Arlo Go firmware updates by using cellular data to download. Small Arlo firmware updates use about 0.008 GB (8MB) of data that usually happens around 4 times a year, whereas the major Arlo updates can use up to 0.052 GB(52MB) of data which occurs once a year.

• Start the Arlo app or log in to my.arlo.com.

• Tap or click Settings > My Devices.

• Select the camera that needs an update.

• Tap or click on the Device Info > Firmware > Update.

• Waite for the system to update completely.When the system’s camera’s LED blinks orange and blue that means the firmware is downloading and installing. As the camera firmware is installed, the camera reboots, and the LED automatically gets turned off for about 1 – 2 minutes. After the update end the camera will syncs to the Arlo base station again and LED starts blinking rapidly in blue.

• Steps need to be followed repeatedly for each camera that needs an update.