Fusion 360 Lessons

3. Bowl: It was our introduction to the fusion feature revolve. We first created the curve and revolved it to a bowl. We shelled the top of the bowl

4. Macaroni: Repeating what we learned with revolve, we created a circle and revolved it 180 degrees around a single axis in the middle. This created a macaroni. We then shelled the top.

5. Vase: Using the same idea, I made the edge design first with lines and 3 point arcs and revolved it 360 degrees. We then shelled the top.

6. Glass Jar: The glass jar was made similarly using revolve by drawing the edge and revolving it 360 degrees. We then applied a glass appearance on it.

7. Lego Brick: I first created the rectangle and then made the circles using extrude. I then used the rectangular pattern to put the 8 circles in order on the top rectangle. I then extruded the bottom of the lego block and created a circle underneath using offset. I then used a rectangular pattern again underneath to make the three circles underneath.

8. Water bottle cap: This was a small quiz we had. I started by making the edge of the bottle cap and not doing the bottle handle. After making the bottom part using revolve. I made a U shape extruding it and moved it on top of the handle to create a bottle cap.

9. Candle holder: Using the same strategy I drew the edge with curves and three point arcs and then revolved it to create the candle holder

10. Tissue box: I used many walls and mirror to create a box. I first made the base the side walls mirroring the them to make the whole thing base and side walls. I then added a top onto it and drew a rectangle on top to make a hole extruding it inward.

11. Snowflake: I first drew two circles as a base to draw around. Then we drew a hexagon and offsetted it. to make the hexagon near the base. I then drew lines one leg outward with all the designs and did a circular pattern on it to create the snowflake. I then cut the unecesary lines from the design and extruded outward the deisgn by 0.2cm. I also created one circle at one point and extruded it inward for a hole. I then added my name on it using the text utility.