Grab a byte

The first thing I did was plug the LED onto the board, making sure the positives and negatives legs were placed the right way. The I placed the end of the resitor to the longer leg of LED. I then connected a wire to the built in LED 13 and then to the top of the right side of the resistor. I finally connected a wire to GND and to the row of the shorter leg on the LED.

I then coded the LED to blink in 1 second increments.

I repeated the same exact process  for the first LED on all three of the LEDs. I connected the wire to GND and then to the shorter leg of the LED. I then used the spots -12 and -11 to connect wires to the resistor.

I duplicated the code 3 times for each LED and changed the pins to either 12 or 11. I also change the timing to the LEDs could go right after the other.

I started with only one LED like I did in tinker cad to make sure everything work properly. I connect the GND and the pin 13 just like my Tinkercad model.

I then mimicked my tinkercad model onto my board.