Embedded Files
This is my 2D drawing of my connector joint. I did this by uploading the 3D model of the connector joint onto my computer. Then I went the new drawing button and pressed the arrow and clicked from design. I then pressed projected view to get multiple view points. I then used the dimension tool to get the dimensions on each side.
This is my 1x4 lego. I first made a rectangle with correct dimensions and extruded it. Then I made 4 circles on the top and a another circle inside the first circle. I then only extruded the outside circle. After that, I made three circle onthe side and negatively extruded it. Then I shelled the bottom of the rectangle and made the inside circles and extruded them.
This is the lego I will recreate in fusion 360. I started off by taking the dimensions of the lego brick.
I then used the dimensions to create a sketch of the perimeter of the lego. I then extruded the design and added the three circles and extruded them aswell. After that I shelled the bottom and added the inside circles and made a rectangle on the edges
This is my 2D drawing of lego.
This is my partners 2D drawing of their lego design.
I used my partners 2D drawing to create this lego. I made this by makinh two rectangles next to eachother and using the loft tool to connect them as a slope. Then i used the dimenstions to create the circle of the top. After that, I shelved the bottom made 3 circles at the bottom and extruded them negativly.
This is my 2D design of my partners lego.
To make this I went into the create form tool and made a 3.25x3.25 sphere. I then used the edit form tool to twist the sphere and I mirrored the sphere circlely in order to make things easier. To hollow out the sphere, I made an offset plane and created a sketch of the profile of the sphere. Then, I used the revolve tool to hollow it out.
This is my 2D drawing of my flower pot.
This is my 3d printed flower pot. I exported my file as an STL and went into prusa slice to scale it down and slice it. After that I found an unused printer and cleaned it with acohol. I then uploaded the g-code to the printer and printed it.
Problems I Encountered
Problems I Encountered
The one problem I had is when I finished printing my design the inside wasnt hollowed out like it was in my design, which was odd.
Page updated
Report abuse