Shay Wallace ePortfolio

CSWA Practice

1.6 Solidworks Practice

2.4 Solidworks Practice

Image of finsihed product

This is a gif of the finished product

This is the target volume

This is my volume

3.4 Solidworks Practice

Center lines were drawn and dimensioned to a 45 degree angle for easy mirroring

The orginal rough sketch

This is the previous sketch just dimensioned

This is after mirroring and filleting corners

This is after another mirror but this time the mirror was on the bottom face and the right face of the extruded base

Hole and initails were added

Finished Product

The masses are suppose to be as close as possible but im a little off

4.16 Practice

Started on the right plane with the middle extruded circle

Then a rough sketch was made

The sketch was then dimensioned to get an accurate object

Added the angle and the fillet

Extruded both halfs serperatley

After adding hole in bottom

Added Initials

Finished product gif

This is the mass properties looking at volume

This shows the target volume and i was a litle off

5.13 Practice

Here is the finished product with all the planes involved

Gif of finsihed product

Here is the target volume

Here is my volume , not too bad

6.14 Practice

Picture of finished product

Gif of finished product

Ideal volume

My volume

Section 8

Section 9

Picture of finished product

Gif of finished product

This was target center of mass

This was mine

Page updated

Google Sites

Report abuse