1st Sweep: Before starting the engine

Left Panel

Lighting Ext

• Master Light switch -> ON

Aux Comm

• CNI knob -> Back up

Fuel

• Eng Feed knob -> Norm

Elec

• Main Pwr switch -> Batt

Audio 1

• Comm1 knob -> rotate fully clockwise position
• Comm2 knob -> rotate fully clockwise position
• Threat knob -> rotate 12 o'clock

Audio 2

• ILS knob -> INC

UHF

• Left function knob -> Both

Right Panel

Lightning (optional)

• Primary Inst Pnl knob -> fully clockwise
• Primary Data Entry Display knob -> fully clockwise
• Flood Consoles knob -> fully clockwise

Air Cond

• Air Source knob -> Norm

2nd Sweep: Starting engine & systems

Left Panel

ELEC

• Main Pwr switch -> Main Pwr

• Click a little bit above yellow handle to close canopy

Right Panel

Avionics Power

• Power up the MMC, ST STA, MFD, UFC, GPS, DL switches
• Wait until MFDs and DED are powered up
• INS knob -> Align Norm (it will need 8 minutes to align INS, you can check in DED when INS reaches 8.0 and and RDY flashes on the right side of the DED and ALIGN flashes in the HUD). Full aligment will be reach with the value 10.0

SNSR PWR

• RDR ALT switch -> STBY
• Power FCR, Right HDPT and Left HDPT switches

Central Panel

• Switch the HUD on with the ICP SYM thumbwheel (up)
• Click on F-ACK (left eyebrow) to review the PFLD
• reset the MASTER CAUTION light (click on it)

Left Panel

AUX COMM

• CNI knob -> UFC

Central Panel

• Right MFD -> DTE -> LOAD (to load the DTC)

3rd Sweep: The final sweep

Left Panel

ECM

• Left switch -> OPR

THREAT WARNING AUX (below canopy handle)

• Click on Power

CMDS (to the right of THREAT WARNING AUX)

• RWR switch -> ON
• JMR switch -> ON
• CH switch -> ON
• FL switch -> ON
• The PRGM knob can be set to any program (preset through DTC) you like and you should rotate the MODE knob as desired or pre-briefed

HMCS

• knob -> INT

GEAR

• Stores Config -> CAT I or CAT III ( according to your loadout (check the STORES CONFIG caution light) and confirm that all three gear lights are green)

RWR

• Click HANDOFF (sets RWR to diamond float mode)

• Arm the ejection seat by clicking on yellow bar between the seat and the UHF panel

Central Panel

Left MFD

• When radar finishes to start up, turn it on by clicking STBY -> CRM
• Clear errors by clicking TEST -> CLR

Right Panel

Avionics Power

• INS knob -> NAV (prior to rotating to Nav, check first in DED that INS reaches 10.0 and RDY flashes on the right side of the DED and ALIGN flashes in the HUD)