Post date: May 6, 2011 7:22:55 AM
Hooking up to unit:
On units that are sold as kits you will need to connect the parts and do the network setup.
Remove the screws (8) on the top of the radio. Use a standard star screwdriver.
Once the cover is off take your Grey CAT5 cable and insert cable in cable tension adapter.
It will fit very snug, but push cable into box.
Plug up grey Ethernet Cable in Eth0 on Radio
Eth0 is the Ethernet Port nearest the power adapter plug.
Plug up Grey Ethernet Cable into Power&Network side of POE
(closest to power adapter plug)
Plug Grey Ethernet (standard) Eth Side of POE Adapter into your network hub or switch.
DO NOT PLUG IN ANY CABLES OTHER THAN RADIO INTO +/ETH SIDE OF ADAPTER.
Adapter puts 12-18 volts power on pin 4,5,7 & 8, and will destroy network cards, routers hubs and switches not designed to receive its power over its Ethernet port.
Plug unit into running network with dhcp (auto assigned Ip's) with a standard Ethernet cable.
If you plug directly into POE device with computer you must use a crossover Ethernet cable instead.
Basic Computer Configuration
Plug PC/Laptop into same segment of network as your access point.
Set your LAN on your computer to:
Ip 192.168.1.100
Subnet 255.255.255.0
Gateway 192.168.1.1
Ping 192.168.1.2 to see if your can see the access point on the network connection you have.
SSH into 192.168.1.2
admin/terra7 (default username and default password)