Follow these steps in order. Every moving part is locked with a thumb screw that works with a nut that is dropped into a slot in the plastic components. These are M3 square nuts. Finger tight is enough, so do not use tools on the plastic parts.
Unpack everything onto a clear surface. You should have two aluminium ruler halves (1 to 46, and 47 to 99), the bottom-bracket base block, the sliding blocks, the stroage locking block, the seat clamp with 2 optional spacers, the 2 part phone holder, the hands adapter that has two stainless tubes, the crank adaptors (dome, V, SRAM and 2 hex), a hanging hook and the two levelling stands.
Take the 1 to 46 ruler half. Slide the small end block onto the ruler from the 0 end (the end marked 1) and push it right up to the end to ensure that the measurements are correct. Do this thumb screw up fairly tight.
Slide the BB height sliding block onto the ruler from the 46 end and run it all the way down until it is around the 14cm point.
Slide the small block with two holes for the ruleronto the ruler from the 46 end and run it down to roughly the 17 mark. The round pin should be at the back and the second hole for the other part of the ruler should be at thr front. This will allow the two parts of the ruler to slide together neatly for storage and travel.
Slide the larger phone holder component onto the 46 end of the lower ruler and ensure that it is fully inserted. This block joins the two ruler halves of the ruler.
Take the 47 to 99 ruler half. Slide the block with the large hole onto the ruler from the 47 end and run it down to about the 51 mark.
Push the 47 end of the upper ruler fully into the ruler-joint block on the lower ruler until the two halves butt together with no gap, then tighten the thumb screw. The scale should now read continuously from 1 to 99. The halves must be fully seated or every length measurement will be out. You can test this with another ruler if you wish.
Slide the small end block onto the 99 end of the ruler and press it home. This is designed to be tight and may need to be carefully tapped in. If it ever works loose then it can be secured with a small amount of glue.
Take the two parts of the saddle clamp and slide one inside the other. This clamp is used to locate a point on the saddle that is a consistent width. Most bike fitters use either 80mm or 70mm. It doesn't really matter which you use, providing it is consistent. There are spacers provided that allow you to easily set 70/80/90/100 mm.
Push the clamp into the saddle clamp block and lock it with the thumb screw. This piece will turn when in use so that it sits flat on the saddle. To insert it, position it with the points pointing upwards, insert then rotate to point down. Once complete slide this onto the ruler at approx 75cm.
Push the adaptor that suits your crank into the square socket in the base block and secure it with the thumb nut. The universal dome suits most cranks with a central hole. Use the Shimano Hollowtech, SRAM DUB, hex or V adaptor if that matches your crank better.
If the hand position adapter is not fully assembled slide the metal tubes into the holes in the L-shaped block. These are intended to be a tight fit and may need a light tap with a hammer.
If you want to test the hand position adapter, it mounts on the bottom-bracket block at the 0 end of the ruler.
To pack the tool away, undo the hex nut at the ruler joint and separate the halves. Turn the 47 to 99 half end-for-end and slide it back alongside the lower half so the two pieces nest together.
Tighten the thumb nuts on the locking block so that the two halves cannot slide apart in the bag.
Slide the nested tool into the Ryden Bikes bag, add the loose parts and adaptors, and pull the drawstring. The tool can also be hung on the wall by the hole at the 99 end of the ruler.