Embedded Files
Manufacturer: Rockwell - Delta
Model#: 46-450 (North & Middle)
Stock#: n/a
Serial#: 1701683 (North, nearest in picture), 1701682 (Middle)
Acquired: ??
Manufacturer: Teknatool International Ltd.
Model#: G3
Stock#: n/a
Serial#: n/a
Acquired: February 2016
G3 Chucks are for the Rockwell Lathes
G3 Chucks are for the Rockwell Lathes
Manufacturer: Teknatool International Ltd.
Model#: Nova Galaxi DVR 1644 Wood Lathes
Stock#: n/a
Serial#: 5662444 (Jan. 2017)
Serial#: GL 5664155, GL 5664156 (Dec. 2021)
Serial#: GL 5664405 (Jan. 2022)
Manufacturer: Teknatool International Ltd.
Model#: SuperNOVA2 Chuck (purchased as NOVA 24245 Kit)
Stock#: n/a
Serial#: 0093927
Acquired: April 2017
The SuperNova2 Chucks are for the Galaxi Lathes
The SuperNova2 Chucks are for the Galaxi Lathes
FOR STUDENTS / USERS:
FOR STUDENTS / USERS:
Wood Lathe Safety Video (Watch this video for an introduction to the wood lathe and before taking the safety test or trying to use the wood lathes.)
Using a Woodworm Screw with a G3 or SuperNova2 Chuck to Mount Something on the Lathe (a video that illustrates how the screw is used)
5 Things Never to Do with a Face Plate (this video includes a description of what kind of screws and what size screws should be used when using face plates.)
FOR MAINTENANCE / REPAIR:
FOR MAINTENANCE / REPAIR:
MAINTENANCE HISTORY:
MAINTENANCE HISTORY:
1/9/23: Rockwell-Delta Model #46-451, SN: 1712671 taken out of service and surplused. The bearings on the speed control pulleys all froze. Parts not available.
1/11/23: Nova Galaxi 1644 Lathe GL 5664405 placed in service.
1/11/23: Nova Galaxi 1644 Lathe GL 5664156 -- E-stop button replaced (under warranty). It would not reset itself and prevented the lathe from operating.
5/27/25: Nova Galaxi 1644 Late GL 5662444 -- The incoming neutral wire connector became disconnected from the fuse/switch. The red panel had to be removed (and the hand brake that is reverse threaded) had to be removed so the plate could come off. To remove the hand brake wheel, the 4-jaw chuck was installed with a 1/2" thick piece of wood clamped in the jaws to keep the lathe shaft from rotating.
Report abuse