Track Parts

Three Models available

-          Difference is footprint

-          All come with shielded direction switch housing and three discs corresponding to standard track hookups – red, white and black

Standard

-          Length 150mm x Width 90mm

-          Typical mounting platform minimum size 6” x 3 5/8”

Low Profile

-          Length 185mm x Width 50mm

-          Typical mounting platform minimum size 7 ½” x 2 1/8”

Mini

-          Length 130mm x Width 50mm

-          Typical mounting platform minimum size 5 ¼” x 2 1/8”

Required to complete (not included);

-          M4 pan/truss/round head machine screws and blind nuts (recommended) or #8 x ¾” round head wood screws

-          standard ¼” panel mount fuse holder

-          fuse

-          DPDT panel mount switch for 22mm x 30mm hole

-          8-32 x 2” brass machine screws, washers and 8-32 lock nuts

-          Simple one piece design for use with multiple manufacturers controllers

-          Printed in standard colours to match lane colour or can be painted any colour using enamel or lacquer

-          Attaches with 2 screws (not included)

-          Custom designed and 3D printed to match your layout

-          3mm holes for IR LEDs

-          Wire troughs

-          Assembles using thin CA glue or any suitable ABS solvent

-          Mounts with #6 wood screws

-          Finish with MonoKote checkerboard Trim Sheet (recommended) or black/white tape (not included)

• Used to burnish copper tape

• 3D Printed using PLA

• Add your own handle and axle