Performance Parts

NEW! Chassis Stiffeners

Improve handling by stiffening rear chassis
Improve power transmission by better maintaining gear alignment and mesh
Currently available for
- Scalextric Porsche 911 RSR (Falken Tire livery and others using the same chassis)
- Scalextric Mercedes AMG GT3 (GruppeM livery and others using the same chassis)
- Scalextric BMW M3 GT (Turner livery and others using the same chassis)
Simple installation
- Remove rear axle assembly
- Drop in and fix with your choice of adhesive - CA glue, double-sided tape or hot melt (recommended)
- Replace axle assembly and race!

C SiVa Guide Adapters

Allows replacement of stock guide with standard screw guides. Also improves guide depth in the slot for better handling and electrical contact.
Easily replaces Scalextric factory guides.
Also can be used on SCX, Carrera and others.

3D rendering

3D Rendering of C SiVa Guide Adapters. Three different depths are available.

3D Printed Example

Installed in an SCX Mercedes AMG GT3

FF can inline Slot.it Compatible Pod

Uses 3/16" OD single-flanged bushings or bearings on the outside or inside of the axle mounts
Motor is angled for smooth gear mesh using 0 offset gears

3D Printed Example with motor and rear axle assembly installed.

Adjustable Front Axle Blocks

Use in slot cars when there is too much play in the front axle
Adjustable ride height using m2 x 4mm and/or m2 x 6mm grub screws
Installs inside existing axle blocks using two-part epoxy

Inline to Sidewinder Conversion Pod

Used to convert front-motor inline configuration to sidewinder configuration
Allows for easier motor swapping without having to perform a realignment during re-installation
Currently in prototype phase but I have added it to the Order Form

Google Sites

Report abuse