Hive Mind Synthesis
MegaMult
Embedded Files
BOM
BOM
1x Hive Mind MegaMult board/faceplate set
10x Thonk-style 3.5mm jacks
1x 1x4 pin header (optional)
1x 1x2 jumper cable for linking (optional)
BUILD
BUILD
This is a quick, simple build. You add all components to the board, place the faceplate, flip, and solder!
1) Place Jacks
No need to solder yet
2) Place Faceplate
Add the faceplate on top of the unsoldered jacks
3) Flip and solder
Flip the board and balance the ends so that all of the components can hang in place.
Solder the pins on jacks.
At this point you can also add the pin headers on the opposite side of the board, if desired
3) Flip and add nuts
Flip the board to view the faceplate and add knurled nuts around jacks.
USE
USE
It's a passive mult!
Highlighted connections are switched, creating a new mult below, split from the mult above.
Skipping the highlighted connector continues mult from above.
When linking multiple Megamults with cable, you can pass mult signals from module to module in the same way. Just connect the input pins of one module to the output pins of another. You can chain them infinitely in this way
Page updated
Google Sites
Report abuse