Label all the parts, decide and write on the inside so you don't have to worry about sanding them off.

Draw out where the rabbets and dados will go.

Cut Rabbets on edge first.

Handle

Adjust Fence 1/32" so that the lid piece slides easily and cut again.

Dry Assemble to check fit

3/4" Stick for Handle, (Long for Safety)

Roundover using push stick.

Roudover the ends with Miter Gauge

Chop to Needed Length

Find Center

Center Punch

Drill to correct depth with correct bit.

Find Center of board.

Center Punch and Drill

Get Dowel from Duff and Glue

Press Fit and Cleanup Glue

Use multitool to cut dowel flush.

Find center on both ends of rotating piece.

Grab an 8d 2-3/8" nail.

Cut to 3/4" using bolt cutters.

Hammer into center until 1/4" is sticking out the top.

Use needle nose Pliers to hold when hammering.

Use a vice to center punch and hammer the other side.

Use a file to cleanup any rough edges of the nail.

Label which way is the front and layout where the holes need to be drilled on Part A.

Drill Holes to Correct Depth.

Use pliers to bend 90 degrees into sheet metal strip.

Dry assemble and ben sheet metal by hand.